Recent content by idle

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. I

    Issues

    ok so the rear hub was loose tightend it up, clutch shifts good but I still cant get it into neutral. I changed the oil and it was grey and had little metal flakes in it tiny ones so i put new oil and filter. The starter still clicks and then after i hit it like 3 times it starts the bike, and...
  2. I

    Issues

    the front right wheel spins and then stops, the other one spins and spins and spins, the back hub is wobly on the same side. I got wheel bearings for the front, and im gettin the hub welded. Still no neutral and i have no idea how tight or loose the cable should be. Starter clicks, hit it again...
  3. I

    Issues

    ill take a look tomorrow
  4. I

    Issues

    I paid 1800 for it, its a 01 it looked in good shape, but im pretty sure it needs a solenoid, as for the shakeing i have no idea
  5. I

    Issues

    only thing i havent checked on the front end is bearings, its a 400ex fyi. But you guys normally all help out so I figured id try here first, I hope somthing not jacked up on the frame.
  6. I

    Issues

    Ok so i took my quad out todayand the starter is just clicking I think it needs a solonoid. Got it started put a new clutch cable on,and it wont go into neutral while its running, I took it down the road and its wobbleing and pulling all over the place the tires look like one is in a different...
  7. I

    WTB after market a arms

    Im lookin for a set of aftermarket a arms
  8. I

    O no blue smoke! Oil experts needed

    o and before i found out how atv oil is different then car oil i used to run napa in my old quad and it shifted hard but never needed a clutch i rode it for 2 years. so maybe ill just get those seals. Any idea what the part number is for them?
  9. I

    O no blue smoke! Oil experts needed

    yea well if i take it apart ill do hot cam stage one cheap, wiseco piston 1st ovrbore cheap, and valve seals. O and hopefully i just need bearings on the front and biushing and not a ball joint cause ill have to get a new a arm.
  10. I

    O no blue smoke! Oil experts needed

    Anyone know if you can use marvel mystery oil in a warrior, my bike smokes blue on start up but goes away after it warms up and I think it will eventually need a piston and rings but moneys tight right now so im looking to just stop it from smokeing. Marvel has worked on my dads car before but I...
  11. I

    bushings??

    ebay wins i guess
  12. I

    alba

    the cam is a mega cycle by the way
  13. I

    namura pistons?

    so it would be a 11 for the valve o ring, why should i replace it?
  14. I

    namura pistons?

    where can you get valve seals on ebay to? thanks for the responses
Back
Top