Recent content by duneracerweston

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. duneracerweston

    New crankshaft questions

    Mr crankshaft can save that crank and replace the rod and stuff. He does it all the time.
  2. duneracerweston

    Deck Height

    Must be a stroker crank not a stock stroke crank which would cause this.
  3. duneracerweston

    Deck Height

    I just saw the piston hanging out the cylinder. And that is not going to work. I stand corrected. Is that a cheap Ebay kit?
  4. duneracerweston

    1998 Warrior 14:1 366

    looks good on the ground! and is the back of your frame bent?
  5. duneracerweston

    Deck Height

    Your going to be fine with that setup. I run 0.037" on a high dome pistons with zero issues. Your good to proceed
  6. duneracerweston

    ROLL CALL

    it will be more so after i get done with the initial round of testing on these 409s before i have the data to really set down and drw to the conclusions that these parts deserve. that being said it will change the way we look at cams and their use cases if what i have in the works makes the...
  7. duneracerweston

    the differences between the 350/400 air cooled motors.

    as a bit of a introduction, I've been crawling all over these motors for about 14 years now, i have built more then a few record holding hp motors and am still steadily developing with these motors. most of this will be referencing fit to the warrior 350 motor specifically. if you have...
  8. duneracerweston

    the differences between the 350/400 air cooled motors.

    I mainly want to make this thread as a answer to what interchanges, the differences, and such to hopefully answer some of the common asked questions on these parts. bare with me this will take a minute.
  9. duneracerweston

    Hotrods stroker crankshaft

    a properly built head is really helpful to s stroker the main problem is the quality out of the box. im running a 4mil crank but the only thing hotrods is the crank halves. its running oem main bearings, rod pin, rod bearing, thrust washers but im running a custom carrillo rod. the crank fully...
  10. duneracerweston

    MN 2000 Warrior Resurrection

    still love that color orange. it just pops so well.
  11. duneracerweston

    Elite Vote HybridWarrior824

    would be sweet to see a properly done hybrid in the elite for the first time. so few were ever finished properly.
  12. duneracerweston

    660 parts

    your in the wrong group for 660 parts bud.
Back
Top