Recent content by Bruce

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    Aftermarket DG exhaust

    I did put the 150 and 45 Jets in and took out the one inch reducer when I put the Jets in it came with a needle shin so I put the needle in the stock position and put the shim underneath it. Now it will only run 5-10 seconds popping back firing a little bit and die out should the shim be in...
  2. B

    Aftermarket DG exhaust

    That is the size of the Jets that I put in did take out the reducer still having a hard time running can't figure it out
  3. B

    1999 Yamaha 350 warrior will not turn over with electric start

    Just ordered a new starting button combination headlight for 25 bucks
  4. B

    Aftermarket DG exhaust

    Put an aftermarket DG exhaust on Yamaha warrior,ended up putting a 1 inch reducer in the pipe, because I was using the stock carb. Now I upjetted the carb and it is backfiring. My question is should I remove the 1-in reducer and the pipe to get more airflow or less back pressure thanks any help...
  5. B

    1999 Yamaha 350 warrior will not turn over with electric start

    Okay I put a new starter solenoid and starter relay switch installed still no press button to turn over the starter but when I jump the starter solenoid with a screwdriver I've got spark to the spark plug and everything else but just will not work with pushing the button am I just chasing dead...
  6. B

    1999 Yamaha 350 warrior will not turn over with electric start

    Yeah I bought a new solenoid and also a starting relay 20 bucks total delivered see what that does I can disconnect the blue and white wire and the small voltage wires off the solenoid and if I put power to them the motor turns over
  7. B

    1999 Yamaha 350 warrior will not turn over with electric start

    I have two 1999 Yamaha warriors back to back serial numbers one of them I cannot get the starter to turn over I got a green light neutral switch on I bypassed and I can get the motor starter to turn over but to use the push button. It will not even turn over what am I looking at I've been...
Back
Top