Recent content by rolls

did u try a bearing puller?

ended up using .096 worth of gaskets not really sure of compressed size though

after putting the spacer plate in it is right on the timing mark

cool i really hope not, stock it sat right before the timing mark hopefully it will sit right on it i will know soon just got the spacers in today thanks for the reply much appreciated

???

so was running the junk vertex piston for the hot rods stroker kit and it broke between the ring lands with only three hours on it with no signs of detonation, anyways i was wondering if someone knew how much raising my jug .081 would afect my timing?

oil cooler and new valves and springs

Looking for aarms for my raptor 350

right i know they are hard to find but i figured if i were to fing them it would be here

wanting to buy the gytr stator cover and frame guard if anyone has one that they would like sale.

hi guys i'm installing a tusk comp. series clutch it came with one friction ring that is slightly bigger than the rest can someone let me know where that goes?

i had same problem when i did mine, i had to look at the parts schematics on rockymountainatv.com to find where the went. i do remember there are no washers on the balance shaft

hi guys i am in search of good used axle carrier would prefer aftermarket but stock would work, i am also looking for the chrome stator cover and frame guards, i also have for sale a raptor 350 cam, and stock piston

hey guys i am new here!!! i am the proud owner of the first raptor 350 purchased in missouri. i recently rebuilt motor with hot rods stroker crank, vertex piston, and stage 2 hotcam.i have motor tore apart again replacing springs and valves and adding oil cooler will post pics soon!!!