Recent content by pens3529

yay here as well...being a newbie at all this it would be nice to have chat

all good now...took the wiring harness off and put it back on making sure ALL connections are good plus made sure all grounds were nice and tight...what do you know I have spark...so must have been a connection or ground

now all of a sudden I don't have spark anymore...any idea what it could be or where do you start to find what the issue is??

now all of a sudden I don't have spark anymore...any idea what it could be or where do you start to find what the issue is??

got lots of compression now..thanks for the help.....but made a rookie mistake. forgot to put the spacer back in so the stator was coming loose

OK I will see what I can find

and yes still have the pull start but not installed cuz I keep taking cover off

can you help me locate that lever?

I'm using the elctric starter then I seem to lose compression...not using my pull start

OK?? how do I get the compression back?? sorry I'm new to all this...need more info

no idea what you're telling me here

I can easily hear that nothing else is turning..

no I don't have a compression tester...but I can feel lots of compression when I block the hole with my thumb....didn't check the valves at all...I'm a newbie at this...what would cause the valves to stick??

I replaced my one way bearing...put it back in with cover all tight and sealed...I crank it a few times then all of a sudden I lose compression...take it apart don't see anything wrong so put it all back together...crank it,have compression then all of a sudden again no compression...any idea...

ya I'll get you one tomorrow and send it to FB...not sure i know how to do it on here