Recent content by bowtie

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    05 350 stumbling/jetting issue

    I re-adjust the float and actually got it a bit to high because it would very slowly leak fuel from the over flow vent. The K&N and outer were very clean when we got it, and i even rewashed the outer and got nothing out of it. I didn't see any green in the carb and I also used brake...
  2. B

    Teather Killswitch

    Everything I have read says that you ground one end and the other wire goes to the orange wire on the coil. I have one coming for my G/F's 350 and will be installing it sometime this week.
  3. B

    05 350 stumbling/jetting issue

    Ok, so my g/f bought an 05 Raptor 350 SE Friday night that is all original with the exception of a K&N air filter with the outerwear and the end cap/sparky removed. The carb had the original jets in it, 142.5 main, 22.5 pilot, a/f mix is 3.5 turns out, the needle has three clips and is on the...
  4. B

    Hi All

    New to the site but not quads. I have an 06 YFZ that I ride and my girlfriend has an 05 Raptor 350 she just bought Friday night.
Back
Top