01 Raptor shock installation

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
As far as tightening the chain goes, I want to be sure before I mess around with anything. Here is a picture of the back view.

[URL=http://img819.imageshack.us/i/chaintensionbolts.jpg/]
[/URL]

The two bolts stick out are what I assume to be the bolts I tighten to tighten the chain but I probably have to loosen a bolt or two before I do that. Where are those?
 
As far as tightening the chain goes, I want to be sure before I mess around with anything. Here is a picture of the back view.

http://img819.imageshack.us/i/chaintensionbolts.jpg/


The two bolts stick out are what I assume to be the bolts I tighten to tighten the chain but I probably have to loosen a bolt or two before I do that. Where are those?

Top and bottom of the carrier loosens that and there should be 2 lock nuts on the adjusting bolts that you have to back off.
 
20130316_235327.jpg
 
If you dont have a chain break find out how many links you need to take off and lay chain on it side and just grind a little off and take a take a screwdriver and hammer and the link will pop right off just make sure the tabs are ground flush to the link its pretty easy thats all I do! The first gen warriors I believe are a 100 links and the 2nd are 98! The raptor shock install shouldnt have changed anything after mine I put a new chain and was perfect!
 
Back
Top