I just added adjustable A Arms to my Raptor 350. I am curious what everyone runs for toe-in and negative camber.
The information I found says a total of 1/4" of toe-in (1/8" per) and 3 to 4.5 degrees of negative camber is a good place to start. This is supposed to be 1/4 - 3/16" on a 22" tire.
What are you guys running?
I also got a new rear axle and am struggling to remove the large nut on the right side. Is this reverse thread?
Thanks gents!
The information I found says a total of 1/4" of toe-in (1/8" per) and 3 to 4.5 degrees of negative camber is a good place to start. This is supposed to be 1/4 - 3/16" on a 22" tire.
What are you guys running?
I also got a new rear axle and am struggling to remove the large nut on the right side. Is this reverse thread?
Thanks gents!
