Gear idler

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Devin_h33

Member
Joined
Aug 28, 2015
Messages
8
Reaction score
0
Hi I am replacing my starter clutch in my warrior. The rod that holds the gear idler is tripping me up. There is 2 bearings on the rod ( picture below) do they go right next to each other or does something go in between ? Because the schematic is only showing 1. So just look at the pic and tell me if it looks right
(I know the rod goes all the way in)

Also there is 2 marks on the flywheel I believe are labeled t and F I know they are for timing but how I exactly do I time it? Thanks - devin_h33
 

Attachments

  • image.jpg
    image.jpg
    96.9 KB · Views: 16
Last edited:
Back
Top