geeessfore
Well-Known Member
Since ive been messing with the 660, getting in there to adjust valves suck so I made a tool.
You need:
Small screwdriver (or whatever your handle will be)
Square drive screw
Square drive bit
Torch
Vise grips
Your going to heat up small screwdriver tip then once hot enought using the vise grips pull the screwdriver out of handle. Then take and drive square screw into handle. Relax and have a beer.
You need:
Small screwdriver (or whatever your handle will be)
Square drive screw
Square drive bit
Torch
Vise grips
Your going to heat up small screwdriver tip then once hot enought using the vise grips pull the screwdriver out of handle. Then take and drive square screw into handle. Relax and have a beer.