S/A-Linkage Bearing/Replacment

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

CRSZILLA

Active Member
Joined
Jan 11, 2016
Messages
29
Reaction score
0
Location
PA
I am just finishing up my Warrior build & i cleaned up the linkage & i ordered a Pivot Works Linkage kit...now the Linkage that i have had stock bushings & the pivot works kit has needle bearings but i cant seem to get the original stock bush's out of the linkage using a flat punch...Is there an easier way of getting them out so i can install the upgrade bearings from PW

Any info i would Appreciate it...Thanks
 
I would use a press if available, if not, use a vise to do the same thing.
 
I have a Vice but how would i get them out with it ? Can they be pushed all the way threw ? I thought they had to come out from one side & then the other if you know what i mean...Appreciate it
 
I've never replaced a set personally, but they look like they could be pushed all the way through.
 
Back
Top