Search results

I had this problem on my 87. However the linkage was shot so I bought an msr shifter for a yz250 and went direct shift now I can find neutral super easy

Looking good. Someday I'd like to get an extra set of plastics to dye or spray black

I'm glad you said that because I was going to go with .090 to start. But really it's no big deal. Once the cad drawing is done I can just remake the part as many times as needed til I get it right.

Thanks man! I haven't jetted the carb yet but when my quad warms up sometimes it has a high idle and sometimes it's fine? Would that be some sort of adjustment screw or do you think I still have more gunk in the carb

Yesterday I heat gunned my plastics and then buffed them to a gloss came out not too bad. Still a hundred times better than faded ugly looking plastics. On my plate for this week is the skid plates. Deciding between using .090 or .125 thick aluminum. I'm thinking I can have the a...

Thanks I'll definitely look into that as well!

I don't want to pollute my introduction thread with updates and since I'm doing so much n such a short time I figure I will get this out of the way.. All my powder coating is done by me at my work. Sand blasted, 7 stage wash system then powder coat typically black...

Hells yes it's free! We only do like 3-4 colors though unless a special comes in. Another benefit to my job which I haven't used yet is a fiber optic laser that I plan to use to cut skid plates from 1/8 smooth aluminum. Was going to use diamond plate but realized nobody's going to be able to see...

I was gonna buy the black with red netting nerfs off eBay. I think they are "alba". I'll try the heat gun this weekend. If that's the case ill probably pull all the stickers off aside from the yamaha/warrior ones. I was looking at some holeshot knockoff tires like 260 for all four...I keep...

Just left my local yamaha dealer. Picked up my swing arm bearing kit and ordered yoshimura exhaust. Ordering nerf bars and tires tomorrow. Then I'm sandblasting and getting the wheels powder coated either black or lime green... Leaning towards black as the safe bet.

Hey everyone. Names Marcus as the username implies. About three weeks ago I got my 87 warrior from my uncle for free, it had been sitting the past 5-6 years. Got lucky all it took was some clean gas a battery and cleaned the bowl on the carb it fired right up! Now I'm in the process of powder...