So I did get the axle bearings out with some anger >:( a long socket extender, and a hammer. I hit them for at least 20 min before they came out. Those shits were stuck in there big time. I installed the new ones but before that I cleaned and greased everything. I just wanted to make sure if I...
Yeah I have already asked a question over in the problem section about the swing arm bolt. Thing is stuck in there! I am replacing all the bushings and bearings in the rear and in the axle. I want to make it last awhile. It def has some hours on it and I want to make sure I put plenty more.
Actually I needed the pb blast to get out my axle bearings. That stuff is amazing. I hope I can have it all done by Sunday so I can go ride again. I will soak the swing arm bolt with that stuff also and see what happens. I think there is a lot of rust inside there though. Thanks for the tips guys!
I gotta say I hit it pretty good with a rubber mallette and it is in there pretty tight. I will give it a try again tomorrow. I had been replacing the rear axle bearings also. I got them out, but before I did they seemed welded in there. This should be fun too ;)
I want to replace the swing arm bearings and bushings. When you take off the nut off from one side of the swing arm should the bolt just slide out? I am having a very hard time getting that long swing arm bolt out. Do I need to hit it with a rubber mallete to get it out or are there threads on...
Just wanted to say hello to everyone. I just bought a 2000 warrior 2 weeks ago. It rides and runs strong but needs some work here and there but its my new hobby :D. Hopefully I can learn a thing or 2 here too.