Video on Swing Arm Bearing Remove/Install

shop deals on amazon
Advertise with us
Shop deals on ebay
Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
D

dreded

Well-Known Member
Joined
Oct 20, 2009
Messages
165
Reaction score
0
Found this video about removing and installing new swingarm bearings... mine looked just as bad as his does, The video is for a banshee but other than removing the chain cover it is 100% identical

http://youtu.be/ZYh0cROxAqg
 
Do not install swing arm bearings by hammering them in, they must be pressed in!!

DO NOT INSTALL SWING ARM BEARINGS BY HAMMERING THEM IN, THEY MUST BE PRESSED IN!!

See attached installation video how to press them in without a press.
This video is for a dirt bike but can be used for an ATV swing arm also.

Put the bearing in a freezer for about a half hour and put some heat on the swing arm bearing area and they will slide in almost half way before you even start to press them in. :tup: (SEE BELOW VIDEO)

http://www.youtube.com/watch?v=wiFDNRdRhS0
 
You must log in or register to reply here.

Latest posts

Back
Top