gnccallstar
New Member
- Joined
- Mar 10, 2010
- Messages
- 3
- Reaction score
- 0
I was wondering what is the size of the socket to unscrew the front sprocket?
Sprocket socket size?
- Thread starter gnccallstar
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
tyler
Well-Known Member
I have always just used a crescent wrench works fine, and this is the wrong section for this, just saying.
99warriornj
Well-Known Member
bend the tabs back, clamp onto the nut wit and adjustable and give it a good yank. it should brake loose wit now problem. make sure its in gear
bassballs818
Well-Known Member
The actual socket size is 1-1/4" inch. I believe the MM size 32 but make certain before buying.
spdfrk1990
Well-Known Member
Yes the correct size is 32mm and with an impact it comes right off.
hawkster0001
Well-Known Member
- Joined
- Apr 15, 2010
- Messages
- 681
- Reaction score
- 0
comes right off hmmm, thats what the manual said about the rear sprocket hub, and bearings int eh bearing carrier, and look where i am now, not really looking forward to that sprocket, although i do have a 32mm socket, i have all mm upt o about 50mm 
bomber315
Well-Known Member
if your that worried get it soaking in pb blaster now! haha
hawkster0001
Well-Known Member
- Joined
- Apr 15, 2010
- Messages
- 681
- Reaction score
- 0
nah, it came off pretty easy just put the socket on a impact wrench and put it in first, then it came off no problem
