bberck
Well-Known Member
Cut up my Air box today, put some paint on lid and ran crankcase hose to other side. Used a elbow to run hose thru air box and point it down. Turned out ok its under seat anyway was just bored lol
Airbox ''UPDATED"
- Thread starter bberck
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
schppppeeiiddiiiee
Well-Known Member
- Joined
- Apr 22, 2006
- Messages
- 518
- Reaction score
- 0
besure u rejet..
velociraptor350
Well-Known Member
looks good, like spedy said, make sure you bump the jetting up a little.
bberck
Well-Known Member
Already did. Got to check it a little wednesday. Was a little on lean side but had entire lid off and was only 50 degrees out so going to check it again sunday when its warmer and with new lid mod
DeathShadow
Well-Known Member
I hope you are running the prodesign kit I ran mine like that and got a good amount of crap in my motor.
bberck
Well-Known Member
No, but it fit in there real tight and I put the lid back on just for a little more added protection so filter couldnt move up. I'll keep an eye on it though
DeathShadow
Well-Known Member
Watch it extremely carefully - that foam piece on the end of your K&N will start to come off in a few good cleaning periods and eventually come off fully.
bberck
Well-Known Member
Was bored again and didnt like the blue also added a filter ;D
